Contact lens should only be won following a prescription from your doctor. This also applies even if the purpose of wearing them is other than for visual correction. During eye examination, the optician will access your eyes health, myopia, hyperopia and astigmatism. Your visual acuity has to get assessed too before Sacramento contact lenses are prescribed.
In the process of their insertion, the first step should always be washing of hands. They should be adequately dried after that. Then, with your dominant hand, hold the tip of the lens with your index finger and bring down the lower eyelid.
The pointer finger is also used to elevate the lid at the top besides holding lenses. You should look up at this point and place the lens in a gentle manner on the lower side of the sclera. The pointer finger is then removed and the lid released. After doing this, the eye should be closed for a moment to give a chance for the lens to be centered.
In removal, hand washing precedes. They should be dried well before the process is begun. You should first look up and then pull down the posterior eyelid using the middle finger of the principal hand. The pointer finger is utilized to grasp the lens and after squeezing lens between it and the thumb, removal of the contact lens is done carefully. The eye is a very sensitive organ and the lens is a very delicate device. So, a lot of caution should be taken during the process.
The disposable ones are thrown away after a single use. Using them eliminates the need for constant cleaning and storage. However, these processes are not as hard as they are made to sound. As long as you follow the instructions given by the optician, everything will just go smoothly. There are specially made solutions for rinsing, disinfecting, protein removal and conditioning the lenses.
There are some steps to be followed in maintenance of healthy ad relaxed use of these lens. The initial step in this procedure is rubbing the lens for around 20 seconds after application of a cleanser on its sides. The rinsing process must be thorough taking up to 5 seconds using a special rinsing solution.
After cleaning and rinsing follows soaking. This must be done using a fresh cleaning solution. Never make the mistake of reusing the solution. The soaking should last for four hours. Thereafter, the lenses are fine to be worn. In case of any lingering debris, they must be cleared away before insertion.
If they are not in use, they must be kept in specially made cases for safety purposes. They should never be soaked in a saline solution. This does not result to disinfection. The cases may remain closed for a period of thirty days if they are not in use. However, beyond this, they have to be cleaned and disinfected before insertion. The solutions used should be professionally prepared. Otherwise, using something else will not be effective in accomplishing the purpose. Also, the results will be compromised in case the solution is been reused. The case the lens are stored in should be changed on a monthly basis.
In the process of their insertion, the first step should always be washing of hands. They should be adequately dried after that. Then, with your dominant hand, hold the tip of the lens with your index finger and bring down the lower eyelid.
The pointer finger is also used to elevate the lid at the top besides holding lenses. You should look up at this point and place the lens in a gentle manner on the lower side of the sclera. The pointer finger is then removed and the lid released. After doing this, the eye should be closed for a moment to give a chance for the lens to be centered.
In removal, hand washing precedes. They should be dried well before the process is begun. You should first look up and then pull down the posterior eyelid using the middle finger of the principal hand. The pointer finger is utilized to grasp the lens and after squeezing lens between it and the thumb, removal of the contact lens is done carefully. The eye is a very sensitive organ and the lens is a very delicate device. So, a lot of caution should be taken during the process.
The disposable ones are thrown away after a single use. Using them eliminates the need for constant cleaning and storage. However, these processes are not as hard as they are made to sound. As long as you follow the instructions given by the optician, everything will just go smoothly. There are specially made solutions for rinsing, disinfecting, protein removal and conditioning the lenses.
There are some steps to be followed in maintenance of healthy ad relaxed use of these lens. The initial step in this procedure is rubbing the lens for around 20 seconds after application of a cleanser on its sides. The rinsing process must be thorough taking up to 5 seconds using a special rinsing solution.
After cleaning and rinsing follows soaking. This must be done using a fresh cleaning solution. Never make the mistake of reusing the solution. The soaking should last for four hours. Thereafter, the lenses are fine to be worn. In case of any lingering debris, they must be cleared away before insertion.
If they are not in use, they must be kept in specially made cases for safety purposes. They should never be soaked in a saline solution. This does not result to disinfection. The cases may remain closed for a period of thirty days if they are not in use. However, beyond this, they have to be cleaned and disinfected before insertion. The solutions used should be professionally prepared. Otherwise, using something else will not be effective in accomplishing the purpose. Also, the results will be compromised in case the solution is been reused. The case the lens are stored in should be changed on a monthly basis.
About the Author:
Our website offers Sacramento contact lenses at cheaper prices. To choose us as your selected supplier, review our main homepage right here on http://adairoptometry.com.